Olivenorma DIY🌟: The Dawn Of Hope Orgone Pyramid (Material package)

Preparation：

Operation place: Please choose a clean and hygienic place to operate, to prevent the Orgone Pyramid from being polluted in the process of making the Pyramid. (PS: It is more conducive to energy accumulation in some natural environments, such as grasslands, forests, etc.)

DIY Material: Malachite Sphere, Obsidian, 6cm Pyramid Mold, Metatron's Cube Patch, Measuring Cup, Stirring Stick, Glue A and Glue B. (PS: The operator can automatically add or remove accessories according to personal wishes.)

Note: After the glue is prepared, it can only be used immediately. Please pay attention to the amount of glue each time you prepare it. It is recommended to prepare a small amount of glue several times.

DIY  STEP

STEP 1:
Keep the mold open horizontally and Make glue .(PS: The mold opening must be kept level to prevent glue. overflow)
Pour A:B=3:1 into the measuring cup, stir about a minute, and pour the amount of glue 1cm from the bottom of the mold. Let it sit until the glue is completely set. (PS: Completely in about 24 hours at 25℃, adjust time according to local temperature, the lower the temperature, the longer it takes for the glue to set.)

STEP 2:
Put the crystal ball into the mold, and then prepare a small amount of glue again according to the ratio of A:B=3:1. After the glue is mixed well, pour it into the mold until it just covers the sphere, and then use the stirring rod to adjust the position of the sphere. Then wait for the glue to set completely.

STEP 3:
Put the decorative accessories (glass pieces or metal patches) into the mold, again make a small amount of glue in a 3:1 ratio. After the glue is mixed evenly, put the decorative accessories upside down into the mold, and pour the glue until the decorative accessories are just submerged. Then wait for the glue to set completely.

STEP 4:

Make glue again according to the ratio of A:B=3:1. After mixing well, put the crystal crushed stone into the mold, and pour the glue until the crystal is just submerged. Then wait for the glue to set completely.

STEP 5:

Prepare the glue again according to the ratio of A:B=3:1. After stirring evenly, put the torn gold foil into the glue and stir again. Then pour the well-stirred gold foil glue into the mold. Then wait for the glue to set completely.

Steps 4 and 5 can also be combined, so that the effect of gold foil penetrating into the gaps between the crystals can be seen.

Safety Tips: The materials are not edible, please be careful to prevent children from eating them by mistake.

How to Make Your Own Orgonite Pyramid